when your still a want-ta-be machinist and do lousy work you powder coat it.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
METAL CASTING CAN BE DANGEROUS, IF YOU CAN'T HANDEL HOT METAL,LOTS OF HEAT, DON'T DO IT. I WILL NOT BEAR THE RESPONSIBILITY FOR YOUR BEING STUPID.FOLLOW ALL SAFETY RULES, WEAR YOUR SAFETY EQUIPTMENT. PREPARE YOURSELF FOR THE WORST POSSIBLE BURN YOU EVER HAD. LAST BUT NOT LEAST WATCH OUT FOR GREMLINS AND DON'T FORGET ABOUT MURPHY, HE WILL ALWAYS BE THERE.
Followers
Blog Archive
-
▼
2008
(70)
-
▼
June
(33)
- 21 lbs 30 oz
- temp. furnace
- ingot
- mess
- pattern rework
- Better Core needed
- drill bits
- moisture
- core mold out of sand
- core mold almost finished
- pattern with core
- fresh out of sand
- back in the pot
- shop, disorganized and a slob works in here
- lathe 13" regal
- lathe
- mill
- air cylinder
- cyl. heads and bases
- one way check valves for cyl.
- crap, sand to wet
- vise in foam
- mill vise
- pyrometer
- hot enought
- half way there
- rails ready to cast
- rail being machined
- side rails
- rails in place
- lathe carrage base
- broaching
- building a air compressor
-
▼
June
(33)
About Me
- lyndaves
- Chehalis, Washington, United States
- retired from Freightliner Corp. on October 13, 2000 and never worked so hard in my life, like some damn fool kid
No comments:
Post a Comment